DataSheet.in

TH71082 डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - 868/915MHz ASK Transmitter / LO Source - Melexis

भाग संख्या TH71082
समारोह 868/915MHz ASK Transmitter / LO Source
मैन्युफैक्चरर्स Melexis 
लोगो Melexis लोगो 
पूर्व दर्शन
1 Page
		
<?=TH71082?> डेटा पत्रक पीडीएफ

TH71082 pdf
TH71082
868/915MHz
ASK Transmitter / LO Source
General Description
The TH71082 ASK transmitter IC is designed for
applications in the European 868MHz industrial-
scientific-medical (ISM) band, according to the EN
300 220 telecommunications standard. It can also
be used for any other system with carrier
frequencies ranging from 800 MHz to 930 MHz
(e.g. for applications in the US 915MHz ISM band).
The transmitter's carrier frequency fc is determined
by the frequency of the reference crystal fref that is
used. The integrated PLL synthesizer ensures that
each RF value, ranging from 800 MHz to 930 MHz,
can be achieved by using a crystal with reference
frequency according to: fref = fc/N, where N = 32 is
the PLL feedback divider ratio.
Theory of Operation
General
As depicted in Fig.1, the TH71082 transmitter
consists of a fully integrated voltage-controlled
oscillator (VCO), a divide-by-32 divider (div32), a
phase-frequency detector (PFD) and a charge
pump. An external loop filter at pin LF determines
the dynamic behaviour of the PLL and suppresses
reference spurious signals.
The VCO’s output signal feeds the power amplifier
(PA). RF signal power Po can be adjusted in six
steps from Po = –15 dBm to -1 dBm, either by
changing the value of resistor R1 or by varying the
voltage VPS at pin PS/DATA. The open-collector
output (OUT) can be used to either drive a loop
antenna or to feed a single-ended load impedance.
This could be, for example λ /4 monopol antenna
or a 50output port. In any case, an impedance
matching network should be added in order to
achieve maximum available RF power.
Bandgap biasing ensures stable operation of the IC
at a power supply range of 2.2 V to 5.5 V.
Clock Output
The TH71082 feature a clock output (CKOUT) that
can be used to drive a µC. The frequency at
CKOUT is fref/8. The clock output is slew-rate limited
in order to keep spurious signal emission as low as
possible. The voltage swing at CKOUT depends on
the capacitive loading at this pin.
It is approximate 2 Vpp at Cload = 5 pF
ASK Modulation
The TH71082 can be ASK-modulated by applying
data directly at pin PS. This turns the PA on and off
and therefore leads to an ASK signal at the output.
LO Source
Many applications require a stable RF source. For
this purpose, the TH71082 can be used without
modulation as an easy-to-use, PLL-stabilized,
continuous wave (CW) generator.
Frequency Modulation (FM)
For FM operation an external varactor is required. It
simply acts as a pulling capacitor connected in
series to the crystal. Then the analog modulation
signal, applied through a series resistor, directly
modulates the XOSC.
Mode Control Logic
The mode control logic allows two different modes
of operation as listed in the following table. The
mode control pin ENTX is pulled-down internally.
This guarantees that the whole circuit is shut down
if this pin is left floating.
ENTX
Mode
Description
0 TX disabled whole circuit in standby
1 TX enable TX active
Table 1: Modes of operation
TH71082 Data Sheet
3901071082
Page 2 of 10
Dec. 2001
Rev. 004

विन्यास 10 पेज
डाउनलोड[ TH71082 Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
TH7108868/915MHz Fsk/fm/ask TransmitterMelexis
Melexis
TH71081868/915 MHZ Ask Transmitter/lo SourceMelexis Microelectronic
Melexis Microelectronic


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English